PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
3.4.6
Configuring Console Redirection
To remotely install an operating system, you need to first configure Console Redirection.
Set Console Redirection to the same subnet as the management LAN.
1. Click [Partition] - [Console Redirection Setup].
>> The [Console Redirection Setup] window appears. For details on this window, see 1.3.6 [Console
Redirection Setup] window in the PRIMEQUEST 1000 Series Tool Reference (C122-E110EN).
FIGURE 3.30 [Console Redirection Setup] window (example)
2. Set the IP address.
3. Enable each of video redirection, remote storage, and text console redirection.
4. Click the [Apply] button.
Note
After the installation, disable the functions that will not be used.
3.4.7
Powering off and on a partition
To apply the configuration changes to a partition, power off and on the partition.
For details on how to power off and on a partition, see
Remarks
After POST ends, processing continues until the [EFI Shell] window appears when the console is connected to the
partition, and then it stops.
CHAPTER 8 Powering On and Off a
55
Partition.
C122-E107-09EN