Before Starting Setup; Mmb Settings; Partition Settings - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
3.1

Before Starting Setup

This section describes the decisions that must be made before you start setup.
3.1.1

MMB settings

You need to decide the following to configure the MMB:
- IP address, host name, subnet mask, and gateway address
- IP address of the PC used as the MMB console (referred to below as the MMB console PC)
- User accounts
- Name of the PRIMEQUEST 1000 series system (also used as the SNMP system name)
- Management LAN environment ... etc.
For details on MMB settings, see
Note
The management LAN, PSA-to-MMB communication LAN, and remote maintenance LAN must be configured as
networks with different subnet masks.
3.1.2

Partition settings

You need to decide the following before using the partitioning functions to configure multiple partitions:
- Number of partitions
- Partition names
- Partition configuration
- Home SB
For details on partition settings, see
Remarks
If each partition has the same name as the host name of the operating system installed on the partition, partition
management is easier.
3.3 Connecting and Configuring the
3.4 Configuring a Partition.
18
MMB.
C122-E107-09EN