Connecting The San And Built-In Hdd After The Installation - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
15. Configure RAS Support Service. For details, see
Service.
For service life monitoring of the BBU of a RAID card: See
card.
For service life monitoring of the battery of a UPS: See
UPS.
4.4.5

Connecting the SAN and built-in HDD after the installation

For details on connecting the SAN and built-in HDD after the installation, see the PRIMEQUEST 1000 Series SAN
Boot Environment Configuration Manual (C122-E155EN).
1. Change and check the setting of detailed FC card information. For details, see the PRIMEQUEST 1000 Series
SAN Boot Environment Configuration Manual (C122-E155EN).
2. Start HBAnyware. Set the following driver parameters. For details on the setting values, see the manual of
the SAN storage unit.
- Topology
- Queue Depth
- Queue Target
- Link Speed
3. Check registry information. For details on how to check it, see the PRIMEQUEST 1000 Series SAN Boot
Environment Configuration Manual (C122-E155EN). For details on the setting values, see the manual of the
SAN storage unit.
- TimeOutValue
6.9 Configuring Service Life Monitoring by RAS Support
6.9.1 BBU service life monitoring for a RAID
6.9.2 Battery unit service life monitoring for a
81 C122-E107-09EN