Fujitsu PRIMEQUEST 1000 Series Installation Manual page 171

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
-A authPassword:
This is the authentication password (at least eight characters). This setting must match that on the manager
side. The option takes effect only if the security level in the -l option includes authentication. Otherwise,
you can omit the option.
-x privProtocol:
This is the protocol for SNMPv3 message encryption. Currently, the only supported privacy protocol is DES.
The option takes effect only if the security level in the -l option includes encryption. Otherwise, you can
omit the option.
-X privPassword:
This is the encryption password (at least eight characters). This setting must match that on the manager side.
The option takes effect only if the security level in the -l option includes encryption. Otherwise, you can
omit the option.
The following example shows how to send SNMPv3 traps with the "PRIMEQUEST" account to enable
authentication and encryption. The traps are sent to the manager of port 162 with IP address 192.168.0.162.
#trapsess -v 3 -e
authPriv -a MD5
-A 00000000 -x
## SNMPv3 trap setting
\: This indicates that there is no line feed.
After setting the trap destination, restart snmpd with the following command.
#/etc/rc.d/init.d/snmpd restart
After the snmpd restart is completed, restart PSA.
#/sbin/service y30FJSVpsa stop
#/sbin/service y30FJSVpsa start
How to confirm a trap destination setting
To confirm a trap destination setting, use the standard net-snmp trap that was sent during the snmp restart. You can
confirm the correct trap setting by checking whether the trap was received.
Remarks
The trap destination must be running both a trap receiving application and a trap manager to be able to receive
standard net-snmp traps.
Restart snmpd with the following command on the trap source machine.
0x800007e58026577a9f421950a4 -u PRIMEQUEST -l \
DES -X 11111111 192.168.0.162:162 \
143 C122-E107-09EN