Safety Precautions - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 2 Preparing for Main Unit Installation
2.1

Safety Precautions

Observe the following precautions when installing the main unit.
Failure to do so cause damage to the unit or abnormal operation.
- Follow the precautions, warnings, and instructions shown on the main unit.
- Do not block the vent holes.
- Do not install the main unit in a location exposed to direct sunlight or close to
a device that may generate large amounts of heat.
- Do not install the main unit in a location exposed to large amounts of dust,
corrosive gas, or salt spray.
- Do not install the main unit in a location subject to strong vibration. Install the
main unit on a flat surface.
- Use grounded Category 3 wiring or better. Using another type of grounded
wiring may cause abnormal operation.
- Do not route cables under the main unit. Do not allow cables to become taut.
- Do not disconnect the power cables while the main unit power is on.
- If it is hard to push the connector latch of a LAN cable or other cable when
attempting to disconnect the cable, push it with a flathead screwdriver.
Forcibly inserting a finger may cause personal injury or damage the unit.
- Do not place anything on top of the main unit. Do not work above or on top
of the main unit.
- Prevent rapid rises in the ambient temperature during winter. Such an abrupt
temperature change may cause condensation to form in the main unit. Allow
sufficient warm-up time before starting operation.
- Do not install the main unit close to a photocopier, air-conditioning unit,
welder, or other device that generates electromagnetic noise.
- Do not install the main unit close to a device that generates large amounts of
electrical noise.
- When installing the main unit, do not connect it to the power supply line for
an elevator in the facility, since this would expose it to sudden voltage drops.
- Implement antistatic measures at the installation site.
- Confirm that the power supply voltage and frequency are adequate according
to the respective ratings shown on the main unit.
- Do not insert or drop foreign matter into the openings of the main unit. The
main unit contains high-voltage components. If any metallic matter or other
electro-conductive object enters the main unit through an opening, it may
cause a short circuit. This may lead to fire, electric shock, or damage to the
main unit.
- For details on maintenance of the main unit, contact the distributor where you
purchased your product, or your sales representative.
6 C122-E107-09EN