Connecting The San And Built-In Hdd After The Installation - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
Remark
For details on how to install "SNIA HBA API library," see the readme.txt extracted in the
HBA_API_LIB folder.
5. After the installation is completed, reboot the unit.
8. Install updates of PSA and other bundled software.
Check the latest versions of the software at their download sites, and install the necessary updates. For details
on PSA, see 6.2.9 Installing a PSA
9. Configure the dump area.
Confirm that the hard disk has enough free space before collecting a memory dump.
10. Configure the NTP client.
Configure the NTP server on the operating system side. For details, see
11. Save management and configuration information. For details, see
Information.
12. Configure RAS Support Service. For details, see
Service.
For service life monitoring of the BBU of a RAID card: See
card.
For service life monitoring of the battery of a UPS: See
UPS.
4.3.5

Connecting the SAN and built-in HDD after the installation

For connecting the SAN and built-in HDD after the installation, see the PRIMEQUEST 1000 Series SAN Boot
Environment Configuration Manual (C122-E155EN).
Also, for details on driver parameters, see the readme file that comes with the driver.
update.
6.9 Configuring Service Life Monitoring by RAS Support
6.9.1 BBU service life monitoring for a RAID
6.9.2 Battery unit service life monitoring for a
72
7.2 Configuring NTP.
6.8 Saving Management and Configuration
C122-E107-09EN