Settings After Vmware 4.X Psa Installation; Configuring The Network; Table E.1 Settings After Psa Installation (Vmware 4.X) - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
APPENDIX E Notes on VMware Installation
E.4

Settings after VMware 4.x PSA Installation

The settings after PSA installation for VMware 4.x partly differ from those for RHEL. This section describes only
the different parts.
For details on the parts of the setting procedure that are the same as those for RHEL, see the following.

TABLE E.1 Settings after PSA Installation (VMware 4.x)

Settings after PSA installation
Configuring the PSA-to-MMB communication
LAN
Confirming management LAN settings
Confirming SELinux function settings
Confirming the firewall function
Setting the destinations of traps from a partition
Setting the destinations of traps and e-mail via
the MMB
Setting the management LAN IP address
Configuring SNMP to use duplicate disks
Configuring the default gateway
Remarks
PSA is provided only with the PRIMEQUEST 1800E.
All screenshots are display examples, and the actually displayed contents vary depending on the system
configuration and other factors.
E.4.1

Configuring the network

This section describes the network settings required to install and operate PSA.
Use the following workflow to perform the work.
Confirming the PSA-to-MMB communication LAN and management LAN
Configuring the management LAN
Configuring the PSA-to-MMB communication LAN
Usually, the network is configured as shown below immediately after the installation of the operating system.
The interface name, BUS number, and other names must be replaced with suitable character strings according to
the environment.
For VMware 4.x
E.4.1 Configuring the network
E.4.1 Configuring the network
(No settings required)
E.4.2 Configuring the firewall
Same as for RHEL
6.2.5 Setting the destinations of traps from a partition
Same as for RHEL
6.2.6 Setting the destinations of traps and e-mail via the
MMB
Same as for RHEL
6.2.7 Setting the management LAN IP address
Same as for RHEL
6.2.8 Configuring SNMP to use duplicate disks
E.4.3 Configuring the default gateway
270 C122-E107-09EN