Configuring A Partition; Setting A Partition Configuration; Figure 3.20 [Partition Configuration] Window (Example) - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 3 Work before Operating System Installation
3.4

Configuring a Partition

This section describes various information settings for partitions. If your system has multiple partitions, configure
all the partitions.
To apply the configuration changes to a partition, power off and on the partition.
All screenshots are display examples, and the actually displayed contents vary depending on the system
configuration and other factors.
3.4.1

Setting a partition configuration

This section describes how to add and remove an SB, IOB, and GSPB.
Adding an SB, IOB, and GSPB
Add an SB, IOB, and GSPB to a partition as follows.
Operations
1. Click [Partition] - [Partition Configuration].
>> The [Partition Configuration] window appears. For details on the [Partition Configuration] window, see
1.3.4 [Partition Configuration] window in the PRIMEQUEST 1000 Series Tool Reference (C122-E110EN).

FIGURE 3.20 [Partition Configuration] window (example)

Remarks
The above window shows the maximum configuration.
2. Click the radio button of a partition number to add an SB, IOB, or GSPB to that partition.
3. Click the [Add Unit] button.
>> The [Add SB/IOB/GSPB to Partition] window appears. The window displays a list of free SBs, IOBs,
and GSPBs. For details on the [Add SB/IOB/GSPB to Partition] window, see [Add SB/IOB/GSPB to
43 C122-E107-09EN