Configuring The Psa-To-Mmb Communication Lan; Table 6.3 Settings Automatically Added/Changed During Psa Installation - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 6 Work after Operating System Installation (PRIMEQUEST 1800E)
- Operations management software cannot collect information on the partition side.
- Even under an REMCS agreement, no software errors are reported.
- Hot maintenance of hard disks is disabled. The partition must be stopped for maintenance.
- PRIMECLUSTER linkage is disabled.
Remarks
- SVIM installs PSA as it installs the operating system. For details on SVIM, see the ServerView Suite
ServerView Installation Manager.
- For details on how to manually install PSA, see
Uninstallation .
- The following table lists settings for PSA operation. The installer automatically adds or updates these settings
during PSA installation.

TABLE 6.3 Settings automatically added/changed during PSA installation

Target
syslog.conf file
snmpd.conf file
snmptrapd.conf file
services files
snmptrapd start option
snmpd start option
Dedicated PSA-to-MMB
communication LAN interface
iptables setting
SELinux configuration file
(/etc/selinux/config)
SELinux setting
Note
If you change the IP address of the dedicated PSA-to-MMB communication LAN on the MMB side or partition
side, you need to then restart PSA. Otherwise, a display error may occur in the [PSA] window of the MMB Web-
UI. Moreover, PSA would not be able to report any detected errors.
6.2.1

Configuring the PSA-to-MMB communication LAN

This section describes how to confirm the settings for the PSA-to-MMB communication LAN.
Communication between PSA and the MMB requires an active NIC (network interface card) connected to the PSA-
to-MMB communication LAN.
APPENDIX B Manual PSA Installation and
Action
Add setting
Add setting
Add setting
Add setting Added port: The installer does not check for
duplicate port numbers when a setting is added to
the fj-webgate (24450) services file. Change
settings as needed.
Change
Change
Set IP address Referring to
communication
Add setting
Change SELinux is disabled only for RHEL5. If SELinux
is disabled, do not change the settings.
Add setting The policy module is added for RHEL6 or later
only.
130
Remarks
6.2.1 Configuring the PSA-to-MMB
LAN, change settings as needed.
C122-E107-09EN