Assembly Instructions; Mount The Upright; Snap Side Cover Into - Landice L Series Diagnostic And Service Manual

How to Install
STEP 1
STEP 2
STEP 3 Mount the upright
STEP 4 Snap side cover into
place

ASSEMBLY INSTRUCTIONS

Lay the treadmill on the ground.
Using a razor blade knife cut the box just
above the brass staples along all sides of the
box.
DO NOT cut through the center of the box, as
you could hit the treadmill.
Remove the box and discard.
The treadmill components are held together
with plastic strapping.
Carefully cut and remove the strapping and
remove the treadmill from the pallet.
Carefully remove the upright side cover from
the upright assembly.
Slide the upright down onto the 8 side frame
bolts. Be sure the washers are located on the
outside of the upright and against the head of
the bolt. Tighten bolts with a 3/8" extended
socket.
• For L8 models insert and tighten the top
frame bolts. (These bolts can be found in the
hardware kit)
Carefully align the side frame cover. Working
from top to bottom, snap the upright side
cover into place.
23