ROAD RUNNER SUPPLEMENTAL ASSEMBLY INSTRUCTIONS
(Follow these instructions in conjunction with Step 10 on page 3 of your manual.)
On the Road Runner, there are three wire harnesses that must be connected after the
1.
The main harness (9 multicolored wires in a gray sheath) should be routed under the
elevation motor and secured with the supplied harness restraint clip or wire tie. It is plugged
into the circuit board partially hidden by the CD changer.
______________________________________________________________________________
2.
Snap the DC power supply harness (two black wires with a large snap-on connector) into the
mating connector on the DC power supply.
upright assembly is mounted to the frame of the treadmill.
112