Display Control Package (Dcp) Installation - Landice L Series Diagnostic And Service Manual

DISPLAY CONTROL PACKAGE (DCP) INSTALLATION

1.
Attach Heart Rate Control (HRC) module and bracket
assembly to left upright leg. You will need to remove the
control panel attachment screw in order to mount bracket.
Next route the Pulse Bracket through the end cap bracket and reassemble it to the treadmill.
Two bracket screws
3.
Install the DCP control panel assembly into the control
panel frame.
4.
Insert upper wire harness (located on the right hand side
upright) into the display board. The harness connection has a
locking clip designed to keep the harness connection tight.
Make sure this clip is locked into place.
5
Secure upper wire harness to upright leg. The harness
snaps intotwo "J-clips" mounted to the upright leg.
6.
Refer to your owner's manual for remaining assembly instructions.
2.
The HRC wire harness needs to be routed between the end cap
bracket and control panel frame. Remove the control panel end cap
bracket in order to properly route this harness. There is a notch in
control panel frame for harness to pass through.
J-CLIP #1
77
Harness to display
J-CLIP #2