Drive Roller/Front Roller - Landice L Series Diagnostic And Service Manual

L8
1. Remove Frame Rail Cap from left side (4 Philips Head Screws) and rear (2 Philips Screws)
2. Remove End Caps ( 2 Philips Head Screws)
3. Remove 9/16 Roller Bolts (2 Bolts). Note: See section on Tracking and Tensioning
4. Remove Roller.
5. Reverse to install

Drive Roller/Front Roller

L7
1. Elevate treadmill to Maximum elevation.
2. Remove Motor Cover (4 Philips head screws)
3. Remove Traction Strip from left side Frame Rail Cap (7 Philips head screws). Note: Felt
washers, (3) under machine screws.
4. Loosen Take-up Roller bolts with 9/16 wrench so Treadbelt is loose. Note: See section on
Tracking and Tensioning
5. Loosen tension on Drive Belt adjustment screw. This nut (7/16 wrench) is located underneath
motor pan. Note: See section on Tracking and Tensioning
6. Tilt motor toward rear of treadmill so Drive Belt is loose enough to come off Drive Roller Pulley.
7. Remove Philips Head Screws (2) that hold Drive Roller in place.
8. Remove Drive Roller.
9. Reverse to install.
L8
10. Elevate treadmill to Maximum Elevation
11. Remove Motor Cover (4 Philips head screws)
12. Remove Frame Rail Cap from left side (4 Philips head screws) and rear (2 Philips head
screws).
13. Loosen Take-up Roller (9/16 wrench) so Treadbelt is loose. Note: See section on Tracking
and Tensioning
14. Loosen tension on Drive Belt adjustment screw. This nut (7/16 wrench) is located underneath
motor pan. Note: See section on Tracking and Tensioning
15. Tilt motor toward rear of treadmill so drive belt is loose enough to come off Drive Roller Pulley.
16. Remove Philips Head Screws (2) that hold Drive Roller in place.
17. Remove Drive Roller.
18. Reverse to install.
76