Assembly; Base Assembly Instructions - Landice 90 Series Owner's Manual

Rehab treadmill

Hide thumbs Also See for 90 Series:

Table of Contents

Installation

2.3.

Assembly

WARNING

Locate the plastic bag that contains the Owner's Manual and

the 90 Series Hardware Kit.

• 90 Series Hardware Kit contains:

•

• Medical Rail Hardware: The medical rail hardware is

attached to the medical rail: (2x) 5/16" bolts and (2x) 5/16"

lock washers (Figure 2-6).

• Frame Hardware: Frame hardware, (4x) 1/4x20 self-tapping

screws are started in the frame at the appropriate mounting

points (Figure 2-6).

1. Position the base where the treadmill is to be located:

•

Do not remove the wire tie protruding from Upright Center

Note:

Hole on upright. You will need this to guide the upper wire

harness down through the upright in "Plastic Bridge

Installation" on page 30.

Failure to leave ample clearance at the rear of the

treadmill could result in the user becoming trapped

between the treadmill and the wall should the user

accidentally trip and fall while exercising.

Handrail screws-12x

Console screws-4x

Cup holder screws-6x

Allow a minimum clearance of 18 inches (46 cm) on

each side of the treadmill.

Allow a minimum clearance of 6 feet (183 cm) at the

rear of the treadmill.

Table of Contents