Install Side Cover Screw; Check Drive Belt Tension; Route The Wire Harness; Install Motor Cover - Landice L Series Diagnostic And Service Manual

STEP 5

Install side cover screw

STEP 6

Check drive belt tension

STEP 7

Route the wire harness

STEP 8

Install motor cover

ASSEMBLY INSTRUCTIONS
Align the side frame cover beneath the end
cap and install the Phillips head screw.
Tighten the Phillips head screw until side
cover aligns with endcap.
Check the tension on the drive belt by placing
the drive belt between your thumb and
forefinger and twisting.
The proper twist is 45°. If the belt needs to be
adjusted use a 7/16" socket and turn the bolt
underneath the motor pan attached to the
hook screw.
HOME:
Route the wire harness UNDERNEATH the
elevation motor and secure with tie-wrap
provided. Plug connector into circuit board
until it snaps into place.
COMMERCIAL:
Route the wire harness AROUND the
elevation motor and secure with tie-wrap
provided. Plug connector into circuit board
until it snaps into place.
Attach motor cover with Phillips head screws
provided. Plug treadmill into a dedicated 15A
outlet.
24