Assembly Instructions - Landice Rehabilitation Treadmill Owner's Manual

STEP 4:
Secure upright to frame
• Slide the upright down onto the
8-side frame bolts.
• Tighten bolts with a 7/16"
extended socket.
STEP 8:
Secure hand rail
• Press the dome plugs into the
large access holes on the side of
the handrails.
• Finish tightening the handrail
bolts from STEP 5.
• Note: Med Rails go to
Appendix A.

Assembly Instructions

STEP 5: Prepare to install
STEP 2:
Cut the box off the pallet
hand rails (Med Rails: the
word handrails refers to the 4"
clamps for steps 5-8)
• The handrail mounting bolts
have been threaded into the rails
for shipping. Remove them.
• Attach both handrails by first
hand-starting the bolts through
the upright and then using a
1/2" socket. Leave about 1/8"
of slack.
(DO NOT TIGHTEN FLUSH TO
SURFACE).
STEP 9:
Mount the POD
• Remove "POD" console from its
box.
• Carefully mount it on top of the
upright. SUPPORT IT AT ALL
TIMES, IT DOES NOT
SECURELY REST ON TOP
UNTIL IT'S BOLTED DOWN.
• Remove the partially threaded
bolts from the inside of the
POD, and bolt them from the
bottom up (see picture below)
using a ½" socket.
STEP 6:
Place crossbar
• After mounting both handrails,
gently lower the curved crossbar
into position between them.
• Each end of the crossbar
should cover the two smaller
access holes that are cut into
the handrails.
• Leave contact heart rate
connection harness hanging
for now.
*OPTIONAL Contact Heart Rate Assembly
Skip to Step 12 if treadmill has standard crossbar
STEP 10:
Connect contact bar
• Carefully insert display membrane
into the bottom edge of the POD
exposing back connections
• Feed the contact heart rate
harness through the access hole
in the inside of the left upright
(insert strain relief provided).
Feed harness up into the
control panel.
• Pull back the membrane and
connect harness to white 3-pin
connector along the bottom edge
of the display board.
STEP 7:
Secure crossbar
• Using an extended 1/2" socket,
carefully guide the 2 inch bolt
with lock washer into the big
access hole in the side of the
handrail.
• Once the bolt reaches the
crossbar, tighten it.
• Repeat this step with the other
handrail.
STEP 11: Ground the contact
bar
• Temporarily back out the nearest
Philips head screw in reach of
the ground harness from the
POD mount plate (see picture)
• Insert ground eyelet, and secure
the screw to mount plate once
again.
• SOME CONTACT BARS DO
NOT USE A GROUND WIRE
2