Landice L Series Diagnostic And Service Manual page 71

UPPER DISPLAY BOARD
1. Remove screws from upright on either side of display.
2. Remove Caps from Display.
3. Display is attached to upright with Velcro. Pull from top of display to remove.
4. Remove Membrane from Display.
5. Disconnect main wire harness clip. (See Diagram below) IMPORTANT:Remove the display
board from the membrane BEFORE removing the wire harness from the defective display
board. Please review the following to prevent breaking the connector: The wire harness
locks into place on the display board. Press firmly down on the clip to unlock and
slowly move the harness side to side until it is disconnected from the display board.
6. Reverse to install.
MEMBRANE PANEL
1. Remove screws from upright on either side of Display panel.
2. Remove Caps from Display panel.
3. Display is attached to upright with Velcro. Pull from top of Display panel to remove.
4. Disconnect main wire harness clip.
5. Lay display on a clean towel on a workbench and carefully remove Display Board from
Membrane panel.
6. Reverse to install.
FACEPLATE (Replaces Membrane Panel on Sport Trainer and Pro Sports Trainer Models)
1. Remove screws from upright on either side of Faceplate.
2. Remove Caps from Faceplate.
3. Faceplate is attached to upright with Velcro. Pull from Top to remove.
4. Disconnect main wire harness clip.
5. Lay Faceplate on clean towel on workbench and carefully remove display board.
6. Reverse to install.
Press Down Here
71