(System Message Menu) - Denso BHT-904B User Manual

4.5.15 Downloading/Uploading the System Message File

(SYSTEM MESSAGE Menu)

The system message file is a file (file name: "_B90MSG.FN3") used by the system to display messages
such as "Shutdown in progress. Do not remove the battery." or "Charge the battery!".
Downloading/Uploading the System Message File
(1 ) Upload the system message file to the host computer and so on.
(2) Download the uploade
 Up
loading the System Message File
C reate a system message file based on the current system message settings and upload it to the host
computer and so on. After uploading, delete the created system m
 Downloading the system message file
Receive the system message file from the host computer and so on to which it was backed up, and after
setting the stored system messages, delete the received system message file.
The communication parameters, communication protocol, a
c ommunication environment" in section "4.5.6 System Environment Settings" are used when uploading
a nd downloading.
System messages are normally set when the BHT is shipped from the factory, and
 Supplement 
therefore operation at this menu is unnecessary.
Use the following procedure to download and upload the system message file.
1.
Press the [6] key while holding down the SF key at the SYSTEM
MENU.
The SYSTEM MESSAGE menu displays as shown on the right.
[1: DOWNLOAD]:
Downloads the system message file.
[2: UPLOAD]:
Uploads the system message file.
Refer to the following section for details of the above items
Press the Backspace/clear key to return to the SYSTEM MENU.
d system message file at another BHT.
Barcode Handy Terminal
essage file.
nd interface set at "[5] Setting the
139