Denso BHT-904B User Manual page 101


"5: OPEN "COM:" DETAIL": OPEN "COM:" communication c
For the communicati
th e system mode setting can be used. Therefore, it is not necessa
condition setting. Even if the transmission speed must be changed, the use
changed.
1.
S elect "5: OPEN "COM:" DETAIL" at the SET COMMUNICATION
NT key.
E
T he OPEN "COM" DETAIL screen appears.
Th e highlighted setting is the current setting.
"1 : SETTINGS FROM"
Sets the communication condition setting for the user program (OPEN
"COM:") created via BHT-BASIC to either the setting specified in the
user program or via the system
"API" :
Uses the setting specified in the user program (default).
"SYSTEM":
Uses the system mode setting (setting specified in the us
Communication condition
In terface in use *1
Transmission speed
Serial communication
protocol
*1: Regardless of the interface specified in the user program, the operation is carried out using the
interface specified in the system mode. e.g., even if OPEN "COM:2" is specified; if COM1 is specified
in the system mode, the operation is carried out using COM1. Note, however, if COM3 or COM4 is
specified, the operation is carried out according to the setting specified in the user program.
on condition setting for the user program (OPEN "COM:") crea
mode setting.
System mode setting screen
("SET COMMUNICATION" menu)
"3:COM PORT"
↓
"1:BASIC"
"1:OPTICAL"
↓
"1:PARAMETER"
↓
"1:TRANSMIT SPEED"
"2:PROTOCOL TYPE"
Barcode Handy Terminal
ondition setting
ted via BHT-BASIC,
ry to specify the communication
r program does not need to be
menu and then press the
er program is not used).
Target API
OPEN "COM:"
Out .pnCmPrtcl (6060)
87