Denso BHT-904B User Manual page 179

Message
P r o g r a m r e s t a r t s
a u t o m a t i c a l l y .
P r e s s t h e [ E N T ]
k e y
P r o g r a m r e s t a r t s
a u t o m a t i c a l l y .
P r e s s t h e [ E N T ]
k e y
( A p p l i c a t i o n E r r o r )
BHT Response
The BHT displays this error
message and automatically
runs the execution program
from the point of start-up.
The message continues to
display.
If this error occurs, the BHT
beeps five times.
If this error occurs, the BHT
beeps five times.
The message continues to
display.
The message continues to
display.
Barcode Handy Terminal
Cause
Operation was terminated
without turning OFF the
power normally and
therefore the application
resume information has
been lost. The application
is relaunched.
After shut down
abnormally, so unsaved
data was lost.
During execution of System
Program, the System
Program has attempted to
write onto the
write-protected area of the
memory.
(xxxxxxxx: Error address)
During execution of System
Program, the System
Program has received an
invalid command code.
(xxxxxxxx: Error address)
System Program error has
occurred. The application
restarts from the beginning.
System Program error
which is caused by the
application has occurred.
The application restarts
from the beginning.
Countermeasure
If this error occurs
frequently, contact your
system administrator.
Contact your system
administrator.
Unload and reload the
battery and then turn the
BHT ON.
If this error occurs
frequently, make a note of
the displayed message and
codes and contact your
system administrator.
Unload and reload the
battery and then turn the
BHT ON.
If this error occurs
frequently, make a note of
the displayed message and
codes and contact your
system administrator.
If this error occurs
frequently, contact your
system administrator.
Check the application.
165