Denso BHT-904B User Manual page 95

U se the following procedure if necessary to change
1.
Select "5: COMMUNICATION" at the SET
then press the ENT key.
The SET COMMUNIC
r ight.
2.
U se the cursor keys ([▲
highlight the item to be set and press the ENT key.
"1: O PTICAL":
C hanges the in frared comm
"2: CONNECTOR":
Changes the setting of the USB communication p
"3: COM PORT":
Changes the communication
" 4: PROTOCOL TYP
C hanges the co mmunication
"5: OPEN "COM:" DETAIL":
Changes the communication condition setting f
BHT-BASIC.
Refer to the following section for details of the above items.
Press the Backspace/clear key to return to the SYSTEM MENU.
 "1: OPTICAL": Infrared communication parameters
1.
Select "1: OPTICAL" at the SET COMMUNICATION menu and
then press the ENT key.
The SET OPTICAL menu screen displays as shown on the right.
2.
Use the cursor keys ([▲] [▼]) or numeric keys ([1] [2]) to highlight
"1: PARAMETER" or "2: PROTOCOL", and then press the ENT
key.
Press the Backspace/clear key to return to the SET SYSTEM menu.
"1: PARAMETER": Setting the communication parameters
Select "1: PARAMETER" to display the screen shown on the right.
The highlighted setting will be the current setting.
"1: TRANSMIT SPEED": Setting the transmission speed
To change the setting, use the highlight the transmission speed with
the cursor keys ([◄] [►]) and press the ENT key.
Press the Backspace/clear key to return to the SET OPTICAL menu.
the communication environment settings
ATION menu screen displays as shown on the
] [▼]) or numeric key
unication parame
port setting.
E":
protocol setting.
Barcode Handy Terminal
SYSTEM menu and
s ([1] [2] [3] [4]) to
ters .
arameters.
or the user prog m (OPEN "COM:") created via ra the
81