Denso BHT-904B User Manual page 109


Setting the DHCP
1.
Select "3: DHCP" at the SET TCP/IP me
NT key.
E
Th e SET DHCP screen displays as shown on the right. The highlighted
setting will be the cu rrent setting.
Pr ess the Backspace/clear key to return to the SET TCP/IP menu.
Pres s the dot key while holding down the SF key at the SET DHCP menu
to display the NETWORK (
IP address at DHCP)
Pr ess the Backspace/clear key at the NETWORK
retur n to the SE DHCP screen. T
If the ac
 Point 
address, subnet mask or default ga
other than "0.0.0.0", the DHCP does not display on
screen shown on the right.
"1 : TIMEOUT":
Se ts the t imeo ut for acquiring the IP configuration from the DHCP server.
The entry ran ge is from 00001 to 32767 s
 Point  Up to 32767 seconds can be entered, but in actual operation, a maximum of 190 seconds is
available since the number of retries and retry intervals are determined by the system.
To set the DHCP:
(1) Press the ENT key.
(2) The mode changes
numeric keys.
To delete a single ch
the Backspace/clear key or press the SF and Backspace/clear
(3) Enter the desired val
Press the Backspace/clear key to return to the SET FTP menu.
DHCP) screen (acquisition check s
.
quired IP configuration is displayed when the IP
econds.
to entry mode and the cursor displays, allowing the setting to be entered with the
aracter, press the Backspace/clear key. To delete the entire entry, press and hold
ue, and then press the ENT key.
Barcode Handy Terminal
nu and then press the
creen for
(DHCP) screen to
teway is set to a value
the
keys simultaneously.
BS/C key   SF + [.] key
95