Time Zones - DKS 1812 Owner's Manual

2.7.6

Time Zones

Default setting in step 3 is 0 (Time Zones are OFF).
This programming sequence sets up time zones (up to 4) that can be applied to the device access
codes programmed into the 1812. These time zones can be turned on or off once they have been
programmed.
1. Press * 3 6 and enter the MASTER CODE. [ * 3 6 _ _ _ _ (beep)]
2. Enter a time zone number (3, 4, 5 or 6) then press *. [ _ * (beep)]
Do not use 0, 1 or 2 for time zone numbers. These are already used; 0 = always deny,
1 = 24/7 access for relay 1, and relays 3-8; 2 = 24/7 access for relay 2, and relays 3-8.
3. Press 0 * to turn time zone off, OR press 1 * to turn time zone on. [ _ * (beep)]
You can terminate here (step 11) if you have previously programmed the time zone schedule
and only ON / OFF is desired.
4. Enter the begin time hour (01-12) and minutes (01-59) then press *. [ _ _ _ _ * (beep)]
5. Press 0 * for AM, OR press 1 * for PM. [ _ * (beep)]
6. Enter the end time hour (01-12) and minutes (01-59) then press *. [ _ _ _ _ * (beep)]
7. Press 0 * for AM, OR press 1 * for PM. [ _ * (beep)]
8. Enter the days of the week that the time zone is to be active then press *.
[ _ _ _ _ _ _ _ * (beep)]
Sun = 1, Mon = 2, Tue = 3, Wed = 4, Thu = 5, Fri = 6, Sat = 7.
You can enter up to 8 numbers here (1-7). For example, for the time zone to be active only
on Saturdays and Sundays, enter 1 7. The order of the numbers is not important; 17 is the
same as 71.
9. Enter the relay number(s) that the time zone will apply to, then press *. [ _ * (beep)]
You can enter a single relay number here; all relay numbers, or any combination of relay
numbers.
10. Repeat steps 2 through 9 to program the other time zones.
11. Press 0# TOGETHER to end. [0# (beeeeeep)]
1812-162-B-6-09 Page 45