Relay Activation; Relay Activation Check - DKS 1812 Owner's Manual

4.2.3

Relay Activation

The 1812 system relays can be activated from the house. Refer to the tone open numbers that
where programmed in section 2.4.8 to determine each of the activation numbers.
•
Momentary Activation (Relay activates for its programmed strike time)
•
Hold Open (Relay will activate and remain activated).
•
Deactivate (Relay will deactivate)
•
Hold 1 Hour (Relay will activate for 1 hour and then automatically deactivate)
To activate the relay(s) from the resident's house, perform the following steps.
1. Pick up your telephone and press * 7. [ * 7 (beep)]
2. Enter the desired tone open number (2.4.8). [ _ (beep)]
3. Hang up.

4.2.4 Relay Activation Check

The 1812 can be called to check if relay 1, relay 2, or both relays on the 1812 main circuit board are
latched and holding a door or gate in the open (unlocked) position.
1. Pick up resident's telephone and press * 7. [ * 7 (beep)]
2. Listen for the following sequence of tones. No tones: neither relay is activated. Relay 1
activated: beep - pause - beep - pause . . .Relay 2 activated: beep beep - pause - beep
beep - pause . . .Both relays activated: beep beep beep - pause - beep beep beep - pause .
. .
3. Hang up.
Page 52 1812-162-B-6-09