Section 2 - Programming; Programming The Master Code - DKS 1812 Owner's Manual

Before You Start
IMPORTANT! We strongly suggest that you become familiar with these programming
instructions before beginning any programming of the 1812 Access Plus system.
The 1812 has been programmed at the factory with many of the programming parameters already set
(default setting) for a typical residential application with a single 1812. There is no need to reprogram
these parameters unless you want to change them. For easy reference, refer to the chart on page 32
that list the various programming functions and their default settings.
2.1

Programming the Master Code

This programming step sets the system MASTER CODE. The master code is the four-digit number
required to gain access to the system memory. The master code can only be programmed from
the system keypad.
Default setting is NONE. You MUST program a Master Code.
1. Open the cabinet of the telephone entry system and press the master code button. The
Blinking LED next to the button will turn ON.
Note: After you press the master code push button, the LED will turn ON indicating that you
are in the master code programming sequence. If a master code is not entered within 10
seconds, the master code program sequence will automatically end and the LED will return to
a blinking state indicating that you have exited the master code programming sequence.
2. Enter a four-digit master code then press *. [ _ _ _ _ * (beep)] (The LED will revert to
Blinking).
3. Close the cabinet.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1812-162-B-6-09
SECTION 2 – PROGRAMMING
1
2
3
BAD DNS
4
5
6
7
8
RS-485 RX
LAN DOWN
ON
SW1 MODEM / TCP ENB
Phone Line
In Use
Keypad
1 2 3 4 5 6 7 8 9 1011
Master Code
LED
Master Code
Push Button
Mic
Vol
Speaker
Vol
Page 27