Section 3 - Programming; General Programming Information; Programming From A Pc; Programming From The Telephone Entry System Keypad - DKS 1834 PC Programmable Installation & Owner's Manual

Pc programmable telephone entry system

Table of Contents

We strongly suggest that you read these programming instructions in their entirety before beginning any programming of

this telephone entry system.

IMPORTANT!

Many of the advanced features available with this telephone entry system CANNOT be programmed from the

system keypad. These advanced features include relay hold open time zones, security levels, elevator control options and

programming via the internet using DKS servers. If any of these advanced features are used, the system MUST be programmed

with a PC using the DoorKing Remote Account Manager for Windows software, VERSION 6.3.b or higher. Refer to the software

help screen for more information on these advanced features.

3.1 General Programming Information

The DoorKing PC Programmable Telephone Entry System is primarily programmed by

using the DoorKing Remote Account Manager for Windows software. However, the

system can also be partially programmed from the keypad on the front of the entry

system.

Programming the entry system can also be preformed off-site using a user supplied

PC with the DKS software loaded on it. Make sure the RING pin jumper is in place on

the circuit board, which was factory installed. See section 4.6 for more information.

The PC programmable telephone entry system has two relays on the circuit board, all of which are programmable for any

function required. These relays are designated as Relay 1 (R 1), and Relay 2 (R 2).

3.1.1 Programming from a PC

Prior to programming the system with a PC and the DoorKing Remote Account Manager for Windows Software, there is certain

information that you must know and must program into the system before the computer can communicate with the system. See

next page section 3.2 to set-up the telephone entry system for PC programming. Programming the system with a PC may be

accomplished by 1) Phone modem, 2) RS-232 direct connection, 3) RS-422 direct connection, 4) Wireless Connection,

5) TCP/IP LAN direct connection, 6) TCP/IP WAN or Internet, 7) DK Internet-Modem Server. See section 2.4 PC Connection

Options for all layouts and additional hardware that is needed for each. All options require the DoorKing Remote Account

Manager for Windows Software VERSION 6.3.b or higher.

3.1.2 Programming from the Telephone Entry System Keypad

Follow the programming instructions as described in each section of this manual. The system will prompt you with short tones

(beep) when programming steps have been followed correctly, and with a long tone (beeeeeep) when the programming step is

ended. The LCD display will also assist you in viewing the information that you are programming. It is highly recommended that

you complete the resident information in section 7 in back of this manual prior to programming from the system keypad. This

will provide you with the information needed to complete the manual programming sequence (sections 3.2.1 through 3.2.7).

When programming from the system keypad, after each programming step is performed correctly, a short tone (beep) will be

heard. When the programming session is ended, a long tone (beeeeeep) will be heard.

Important Note:

Relay hold open time zones and holiday schedules features CANNOT be programmed from the system keypad.

These advanced features can only be programmed from a PC using the DoorKing Remote Account Manager Software.

1834-065-B-10-14