General Information - Rinnai Arriva Operation And Installation Manual

General Information

Before operation
Read these instructions to get an overview of how to operate, maintain and service your
Rinnai Arriva.
electrical connection
Alternatively the appliance can be direct wired if the power supply is to be concealed. The
electric isolation switch must be accessible after the appliance has been installed.
If the supply cord is damaged and requires replacing, it must be replaced by a licensed
tradesperson. This must be a genuine replacement part available from Rinnai.
Hearths
A hearth is not necessary but can be used for decorative purposes or protection of sensitive
flooring if required. Some general guidelines when installing a hearth.
• It must not obscure the front of the fire
• the bottom of the appliance must be level with the top of the hearth so there is a
continuous level
• Size should be at least the width and depth of the fire
Remember to adjust the dimensions of the cavity to allow for the hearth.
Installation by a licensed tradesperson
Ensure your installer talks to you about the use and care of this appliance and that you
understand these instructions. They also need to complete their installer details on page 43 of
the installation manual and leave the manual with you.
Improper installation, adjustment, service or maintenance can cause serious injury, property
damage or death. Please ensure your installation is completed by a licensed tradesperson.
rinnai new Zealand Limited
the standard electrical connection is to the right hand side of the heater
front assembly. If necessary this can be changed by your electrician to
terminate on the left.
A 3 pin plug is supplied which must be connected to a dedicated earthed
power point. The power point must be 300 mm to the side of the fire
and a maximum of 1500 mm (cord supplied is 1500 mm). It must not
be above the unit as this is a potential fire hazard.
Arriva Operation and Installation Manual: 10343-E
8
05-10