Arriva Installation - Rinnai Arriva Operation And Installation Manual

Arriva Installation

Carefully remove the log set from the carton and place in a safe location until required.
Position the heater body assembly in front of the enclosure opening.
Isolate electrical supply before removing any panels.
WARNING
Use a soapy solution to test all gas connections. If a leak is present bubbles will form
at the leak point. When finished remove any residue with a rag. Prevent any soapy
solution from coming into contact with the electrical components.
Connecting to 1. Remove the right hand side access panel by removing the 4 retaining
gas pipe
2. Extend flexible gas connection through the gas fitting access point to
3. Position the appliance in front of the enclosure so the end of the gas
4. Securely connect flexible gas connection to the gas pipe, testing all
5. Replace right hand panel and secure screws into place.
rinnai new Zealand Limited
screws.
Side
Screws
panel
the outside of the heater body.
pipe aligns with the gas fitting access point.
connections for gas leaks.
Access
point
Gas
connection
Arriva Operation and Installation Manual: 10343-E
31
05-10