General Information - Rinnai Arriva 752 Operation Manual

General information

Before operation please read these instructions to get an overview of how to operate, maintain and
service your Rinnai gas fire.
Electrical connection
The Arriva 752 is fitted with a 1.5 m
power cord and a 3-pin plug. The
standard electrical connection is to
the front right hand side.
The connection is either direct wired
connected to a power point within the cavity.
This must be connected to a dedicated earthed
power point. The electric isolation switch must
be accessible after the appliance has been
installed.
The fire must not be located immediately below
a socket outlet—potential fire hazard.
If the supply cord is damaged it must be
replaced by a licensed tradesperson. This must
be a genuine replacement part available from
Rinnai.
Installation by a licensed tradesperson
Only a licensed tradesperson can install, adjust,
maintain, and service this gas fire. Any work
carried out by a non-licensed tradesperson is
illegal and will void any warranty.
Installer handover
Ensure your installer talks to you about the
use and care of this appliance, and that you
understand these instructions. The installer also
needs to complete the appliance installation
checklist and installer details (p.16), and leave
this guide with you.
Soot deposits
Small soot deposits inside the heater or glass
is normal. Significant soot build-up however
is not normal and will require a service call.
Refer to the troubleshooting section for further
information.
Environmental
Your Rinnai gas fire is
manufactured from a number of
recyclable materials. At the end
of its useful life please consider
what parts could be recycled, for
example scrap metal.
Consult a qualified electrician if direct wiring is required as it must comply with AS/NZS 5601 and AS/NZS 3000 and other
1
relevant local regulations
Servicing
Rinnai has a maintenance, service
and spare parts network with
personnel who are fully trained and
equipped to give the best advice
on your Rinnai appliance.
or
1
Servicing and repair should only be carried out
by authorised personnel, please call Rinnai
(0800 746 624).
For reliable operation Rinnai gas fireplaces
should be serviced every two years, including
inspection of the flue system. If they are in a
particularly dusty environment or subject to
excess lint, for example dog hair, or where
there are newly laid carpets, then annual
servicing would be beneficial.
Regular maintenance and servicing is not
covered by the Rinnai warranty.
Outside flue terminal
On cold days steam may be discharged
from the flue terminal. This is normal for high
efficiency appliances like the Arriva and does
not indicate a fault.
For those with a horizontal
flue terminal, ensure you
keep flammable materials,
trees, shrubs, and any other
obstructions well clear of the
flue terminal.
Arriva 752 operation guide: 12219-C 03-20 | 5