Basic Heater Operation - Rinnai Arriva Operation And Installation Manual

Basic Heater Operation

This appliance has a sealed combustion chamber that requires purging
General notes
before gas can flow and the unit can start. As a result the combustion fan
about ignition
starts several seconds before there are any signs of the Arriva starting.
The normal ignition sequence is:
1. When the On/Off button is pressed the LED will glow red and the
2. Pilot sparker will operate and as soon as a spark is sensed gas will flow
3. When the pilot flame is established gas will flow to the front and then
4. When all burners are on the heater will automatically modulate between
The heater can be operated and stopped without the remote control by
Operation
using the On/Off button on the top panel of the heater. This operation is
without the
called the automatic mode. In automatic mode the default set temperature
remote control
is 22 °C.
(automatic
mode)
If the heater is turned off using the On/Off button on the heater control
panel, when it is turned back on it will lose all timer and clock settings until
the remote is used to re-transmit the information. The remote control
stores the clock, timer and temperature settings of the heater.
For the remote control functions to be available, the appliance On/Off
Operation with
button must be in the On position.
the remote
control
the remote control emits an Infra red signal and must be aimed at the
receiver unit located on the right side of the unit. The normal operating
range is 5 m. This range may vary depending on the position of the
Lock OverrideAuto Off Flame
installation and strength of the batteries.
AM
PM
Temperature Time
Clock Set
Timer 1 Set ON OFF
Timer 2 Set ON OFF
the remote control transmits information to the heater whenever a button
STANDBY
Timer 1
ON
is pressed except when the:
Flame Timer 2
Auto
Override
Off
Time •
Lock
Set
•
When the timers are being set, information is transmitted only when the
'Time Set' button is pressed.
Signal transmissions are confirmed by a brief illumination of the
transmission signal indicator on the remote. The unit will also flash and
beep to confirm the settings have been received.
When the remote is not used for a period of approximately 5 seconds,
the display will default to standby mode, displaying only the time. To re-
activate press any button on the key pad.
rinnai new Zealand Limited
combustion fan starts to purge the system.
to the pilot.
rear burners.
burner settings to achieve and maintain the default set temperature of
22 °C.
remote display is deactivated
lock function is activated
Arriva Operation and Installation Manual: 10343-E
10
05-10