Rinnai Arriva Operation And Installation Manual page 11

Basic Heater Operation
Power
disruption
9 7
Do not unplug
power supply
Flame function
Flame
AM
PM
20
Time
21
Set
Set
Timer 2
rinnai new Zealand Limited
If the power is disrupted while the heater is operating, once the power is
restored, the heater will go into power failure mode. This is indicated by a
flashing zeros in the error display and the LED flashing green.
To reset the heater, press the On/Off button once. Press the Standby/On
button a second time to switch the heater on.
Do not unplug the main power supply to turn the unit off as this may cause
damage. There are safety devices that will continue to operate without
power, however the convection fan is required to operate for several
minutes after the unit is turned off to assist in cooling.
Used to select a desired flame picture and overrides the automatic mode.
There are 7 flame picture settings available.
While the heater is in operation press the Flame button. The heater will
automatically default to the last flame picture setting. The word 'Flame' and
a series of short bars will be displayed to show that the flame function is in
operation.
Use the up and down buttons to select the desired flame picture. The
number of bars illuminated correspond to your selection.
Should the room temperature exceed 40 °C while the flame function is
activated, the heater will switch off automatically. This is a safety feature.
Arriva Operation and Installation Manual: 10343-E
11
05-10