Rinnai Arriva Operation And Installation Manual page 29

Flueing - Arriva Flue Components
Arriva Direct A Flue Kit
For use in walls 115-240 mm
thick (weatherboard). Stainless
steel.
Arriva Adaption Flue Kit
Used for all flueing applications
except direct flueing. Elbow
section requires a 25 mm
clearance from combustibles.
Vertical Terminal
roof cowl and connecting pipe
for termination of flue. Powder
coated, can be cut to size.
Wall Terminal Kit
Used to terminate flue pipe in
horizontal flue terminations when
used with Arriva Adaption Flue Kit
rinnai new Zealand Limited
Arriva Direct B Flue Kit
For use in walls 240-400 mm
thick (block). Stainless steel.
45 ° Bends x 2
45 ° bends used to facilitate
between horizontal, vertical
and downwards flueing.
Condensate Trap
For small number of vertical
through wall installations where
unit is installed against a solid
brick wall or where direct/
adaption flue cannot be used.
Flue Guard
Protection against hot flue gases
when the flue terminates low to
the ground.
29
Arriva Direct Flue Kit
For use in walls greater than
400 mm. Can be cut to size
and used with Flue Pipe for
longer flueing.
Coaxial Flue Pipe 900 mm
extension pipe for horizontal,
vertical and downwards flueing.
Can be cut to size.
Universal Wall Plate
Ø 170 mm
Used if an extra wall cover plate
is required to tidy any installation
work through the wall, ceiling or
floor.
Arriva Operation and Installation Manual: 10343-E
05-10