Care And Maintenance - Rinnai Arriva Operation And Installation Manual

Care and Maintenance

Your heater needs very little maintenance, however the following information will keep it
looking good and working efficiently.
• Switch off appliance before cleaning
NOTE • dO nOt use solvents, all parts of the heater and remote can be cleaned using a soft
damp cloth and mild detergent
• dO nOt attempt to clean the heater while it is operating or hot
Filters
The filters for this appliance are located inside the room air return doors (side louvres) and
consist of 2 metal mesh strips.
The build up of dust on the filter strips reduce the air flow through to the heater. This reduces
the heater's efficiency and can lead to the appliance shutting down. Regular filter cleaning
during the heating season will stop this from happening.
Removing
1. Open the room air return doors. They have spring loaded latches that
filter strips for
cleaning
2. Carefully slide the filter strip upwards until the bottom tab clears the
3. Slide the filter strip down and away from the door and remove.
Cleaning filter
Clean any dust or debris from both sides of the filters using a vacuum
strips
cleaner, a soft dry cloth or a soft brush. NEVER attempt to clean the filters
with water.
rinnai new Zealand Limited
are hinged to open towards the rear. Pressing the front edge of these
doors will unlock the latches and allow the doors to swing open.
lower retaining slot.
Arriva Operation and Installation Manual: 10343-E
15
05-10