Removing A Filler Tray - HP Z600 Maintenance And Service Manual

This section describes how to remove and install a filler tray.

Removing a filler tray

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Lift the drive release latch at the green touch point,
chassis
TIP: Excess power cables can be stored in the filler tray. Remove the cables before removing
the tray from the chassis.
Figure 5-20
90 Chapter 5 Replacing components
as shown in the following figure.
2
Removing a filler tray
Predisassembly procedures on page
Removing the side access panel on page
and then gently slide the filler tray out of the
73).
75).
ENWW