Pci Card; Removing A Pci Card; Installing A Pci Card - HP Z600 Maintenance And Service Manual

PCI card

This section describes removing and installing a PCI card.

Removing a PCI card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
NOTE:
the card support is removed, allowing access to the expansion cards.
3. Remove all cables connected to the PCI card.
4. Push the expansion card retention clamp levers down on the outside of the chassis
the retention clamp as shown in the following figure.
Figure 5-79
5. Remove the PCI card by pulling it up, out of the chassis
TIP: Store the card in an antistatic bag.
6. If you are not installing another PCI card, Install a PCI slot cover and close the PCI retention clamp.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.

Installing a PCI card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
NOTE:
the card support is removed, allowing access to the expansion cards.
3. Select the desired expansion card slot for the PCI card. See
on page 132
136 Chapter 5 Replacing components
An expansion card support is built into the side access panel. When the panel is removed,
Opening the retention clamp
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
An expansion card support is built into the side access panel. When the panel is removed,
for help in selecting a slot.
Predisassembly procedures on page
Removing the side access panel on page
.
2
Predisassembly procedures on page
Removing the side access panel on page
73).
75).
73).
75).
Choosing an expansion card slot
to release
ENWW