Removing A Hard Disk Drive From The Slot Load Optical Bay - HP Z600 Maintenance And Service Manual

Removing a hard disk drive from the slot load optical bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
NOTE:
the card support is removed, allowing access to the expansion cards.
3. Remove any expansion slot cables that might interfere with slot load assembly removal.
4. Disconnect the slot load drive data cable from the system board connector as shown in the following
figure.
Figure 5-41
5. Disconnect the optical drive power cable from the chassis power cable, and the optical drive data
cable from the system board (see
6. Disconnect the chassis power cable from the slot load drive power connector as shown in the
following figure.
Figure 5-42
ENWW
An expansion card support is built into the side access panel. When the panel is removed,
Disconnecting the data cable from the system board
Disconnecting chassis power cable from hard disk drive connector
Predisassembly procedures on page
Removing the side access panel on page
Removing the slot load optical disk drive on page
Removing and installing components 107
73).
75).
97).