Installing The System Board - HP Z600 Maintenance And Service Manual

9. Slide the system board forward as shown in the following figure
Figure 5-86
10. Using the CPU heatsinks as handles, lift the system board out of the chassis, being careful not to
damage the cables and rear panel connectors
NOTE:

Installing the system board

TIP: For convenience, you may install the CPUs and the CPU heatsinks before installing the system
board in the chassis.
1. Ensure that all cables are clear of the bottom of the chassis (see
on page
2. Tilt the system board and lower it into the chassis, ensuring that all standoffs engage the chassis
keyholes.
Ensure that the system board connectors engage correctly with the rear I/O panel.
146 Chapter 5 Replacing components
Removing the system board
If desired, remove system board components such as the CPU heatsinks and the CPUs.
144).
.
.
2
Removing the system board
ENWW