Installing A Filler Tray - HP Z600 Maintenance And Service Manual

Installing a filler tray

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Lift and hold the drive release latch at the green touch point
bay . When the front of the filler tray is near its final position, release the latch, but continue to
2
slide the filler tray inward until the latch closes and engages the filler tray.
TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and
align both devices to get the release latch to close and engage both devices.
While the tray is partially inserted, replace excess power cables in the tray for storage.
Figure 5-21
TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and
align both devices to get the release latch to close and engage both devices.
ENWW
Installing a filler tray
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
73).
75).
while sliding the filler tray into the
91