Hard Disk Drive - HP Z600 Maintenance And Service Manual

6. Connect the optical disk drive data cable to the system board connector as shown in the following
figure.
TIP: Route the data cable along the system board.
Figure 5-35
NOTE:
a hard disk drive in the slot load optical bay.
7. Reassemble the workstation, and then replace the side access cover.

Hard disk drive

This workstation accommodates both SAS and SATA hard drives.
Both 3.5 in. standard hard disk drives or 2.5 in. small form factor (SFF) hard disk drives may be installed
in the workstation.
NOTE: A 2.5 in. hard drive must be mounted in a 3.5 in. adapter before it can be installed in the chassis
blind-mate carrier.
Hard disk drives can be installed in the hard drive bay and the optical drive bay. Drives should be installed
in the hard drive bay first, then in the optical drive bay. Installation in the optical drive bay requires an
optional adapter kit.
The hard drives blind-mate (direct-connect) to chassis mounted connectors, so manual cable
connections may be avoided.
Removing a hard disk drive from the hard drive bay on page 103
Installing a hard disk drive in the hard drive bay on page 104
Removing a hard disk drive from the slot load optical bay on page 107
Installing a hard disk drive in the slot load optical bay on page 109
Removing a hard disk drive from the optical drive bay on page 113
Installing a hard disk drive in the optical drive bay on page 115
Installing dual SFF hard drives in the optical drive bay on page 117
102 Chapter 5 Replacing components
Connecting the data cable to the system board
See Installing a hard disk drive in the slot load optical bay on page 109
Topic
if you are installing
ENWW