Removing The Transport Securing Devices; Fitting The Frame Components - DURKOPP ADLER H868 Operating Manual

Set-up
7
6
Operating manual H868 Version 00.0 - 07/2013
Standard equipment:
Machine upper section (2), Oil pan (3), thread stands with
unwinding arm (1), controller (4), controller operating panel (11),
knee lever (6)
Optional additional equipment:
Table plate (10), drawer (9), frame (8), pedal (7), pneumatic
unit (5), sewing lamp (not illustrated)

6.2 Removing the transport securing devices

All transport securing devices must be removed prior to set-up.
1. Remove the lashing straps and wooden blocks from the
machine upper section, the table, and the frame.
2. Remove the supporting wedges between the machine arm
and needle plate.

6.3 Fitting the frame components

Figure 31: Fitting the frame components
1. Screw the cross bars (4) onto the frame bars (3).
2. Screw the oil can holder (7) at the rear to the upper cross
bar (4).
1
(1) - Head sections of the inner
bars
2
(2) - Inner bars
(3) - Frame bars
(4) - Cross bars
3
(5) - Foot struts of the frame
(6) - Cross strut
(7) - Holder for the oil can
4
5
49