Maintenance - DURKOPP ADLER H868 Operating Manual

40
To interrupt sewing:
• Release the foot pedal in pedal position 0:
The machine stops, needles and sewing feet are down.
To continue sewing:
• Press the foot pedal forwards in pedal position +1:
The machine continues to sew.
To sew over thickened seams:
• Switch on the elevated sewing foot stroke with the knee lever

( Section 5.11 Sewing foot stroke).
To change the stitch length:
• Switch on the 2nd stitch length using the key for the quick

function ( Section 5.13 Switching on the quick functions at
the keypad).
To increase the thread tension:
• Switch on the additional tension using the key for the quick

function ( Section 5.13 Switching on the quick functions at
the keypad).
To sew intermediate bartacks:
• Reverse sewing with the stitch adjustment lever (
5.12 Stitch length) or the quick function key (
Keypad for quick functions).
To finish a seam:
1. Press the foot pedal back completely in pedal position -2:
The machine sews the end strip and the thread cutter cuts the
thread. The machine stops, needles and sewing feet are up.
2. Remove the sewn material.

5.15 Maintenance

This section describes simple maintenance work that needs to be
carried out on a regular basis. This maintenance work can be
carried out by the operating personnel. Advanced maintenance
work may only be carried out by qualified specialists.
Advanced maintenance work is described in the
manual.
Operating manual H868 Version 00.0 - 07/2013
Operation

Section

Section 3.13

Service