DURKOPP ADLER H868 Operating Manual page 45

Operation
CLASSIC
equipment
Operating manual H868 Version 00.0 - 07/2013
Figure 27: Oil level indicator
MAX
MIN
• Check the oil level indicator every day:
The oil level must always be between the minimum level
marking (3) and the maximum level marking (2).
Pour in oil through the refill opening (1) as required:
1. Switch off the sewing machine at the main switch.
2. Pour in oil, up to but not past the maximum level marking (2).
3. Switch on the sewing machine at the main switch.
Note for machines with CLASSIC equipment:
If the oil level falls below the minimum level marking (3), on
CLASSIC machines the oil level indicator lights up in red.
• Switch the sewing machine off and on again after filling with oil
so that the red lamp goes out.
Oil to be used:
Only DA 10 or an oil of equivalent quality may be used for the
machine, which has the following properties:
• Viscosity at 40° C: 10 mm²/s
• Flash point: 150 °C
ATTENTION
Machine damage possible due to incorrect oil.
An incorrect oil type can cause damage to the machine.
Only use oil that complies with the data in the operating
manual.
q
(
1) - Refill opening
(2) - Maximum level mark
w
(3) - Minimum level mark
e
43