Replacing The Hook Thread Bobbin - DURKOPP ADLER H868 Operating Manual

Operation
Operating manual H868 Version 00.0 - 07/2013
reel onto the bobbin. When the bobbin is full, the machine
automatically stops winding. The bobbin lever moves down.
The cutter is automatically moved into its basic vertical
position.
3. Pull off the full bobbin.
4. Tear off the thread behind the cutter.
5. Insert a full bobbin in the hook (see
the hook thread bobbin).
6. Repeat the winding-on procedure with an empty bobbin, as
described above.

5.5 Replacing the hook thread bobbin

WARNING
Risk of injury by the needle point and moving
parts
Switch off the sewing machine before replacing the
hook thread bobbin.
Figure 11: Replacing the hook thread bobbin
5
4
(1) - Hook flap
(2) - 1st hook slot
(3) - Hook spring
1. Lift the hook flap (1).
2. Remove the empty bobbin.
3. Insert the full bobbin so that it moves in the opposite direction
of the hook when the thread is pulled out.

Section 5.5 Replacing
(4) - Hook flap guide
(5) - 2nd hook slot
1
2
3
25