Fitting And Connecting The Sewing Lamp Transformer - DURKOPP ADLER H868 Operating Manual

62
Figure 43: Fitting the sewing lamp
1. Either drill through the hole for 1 large hole (1) or through the
holes for 2 small holes (2).
2. Screw the sewing lamp holder through the hole on the arm
cover.
3. Install the connecting cable in the machine arm and guide the
cable through the hole in the table plate (
the control panel).
4. Stick the sticker with safety instructions onto the front of the
control.
6.13.2 Fitting and connecting the sewing lamp
transformer
DANGER
Danger to life due to electric shock.
The sewing lamp transformer is connected directly
to the power supply.
If you disconnect the sewing machine from the
power supply at the main switch, the sewing lamp
transformer is still live.
Disconnect the power plug before fitting and
connecting the sewing lamp transformer.
Make sure the power plug cannot be
unintentionally reinserted.
1
2
Operating manual H868 Version 00.0 - 07/2013
Set-up
(1) - Large hole
(2) - 2 small holes

Section 6.12 Fitting