Write Uid Screen; Uid Display; Uid Setting; Serial No. Display - Panasonic AG-HPX500 Service Manual

6-5. Write UID screen

This PC EVR software has Write UID screen.
< How to display the Write UID screen. >
1. Select "SYSCON(S)" section after start up the PC EVR software, and click "OK" button.
2. Select "Write UID" in "Tools(W)" menu, Write UID screen will appear on screen.
< Function of the Write UID screen. >
The following display and the setup can be performed on a Write UID screen.
● Setting and display of UID information.
● Display of Serial No..

6-5-1. UID display

Clicking "Read" button as shown in figure, UID information is displayed. The UID information can be confirmed
also with the DIAGNOSTIC menu and Setting Tool screen on PC EVR software. Please refer to item "3-1-4. 1394
UID display" (page INF-8) and item "6-4-5. 1394 UID Display" (page INF-28).

6-5-2. UID setting

Clicking "Write" button as shown in figure, UID information is write to camera recorder (The operation of power
OFF/ ON is required to save the number into the camera recorder). Please refer to item "8. UID Writing
Procedure" (page INF-39) about setting procedure.

6-5-3. Serial No. display

Clicking "Read" button as shown in figure, Serial No. is displayed. The Serial No. can be confirmed also with the
GUI service menu. Please refer to item "4-4. SYSTEM INFO" (page INF-14).

6-5-4. Power supply reboot

Clicking "Re-Boot Power" button, the power of camera recorder automatically OFF and ON.
For UID
For Serial No.
INF-31