Other Functions Screen - Panasonic AG-HPX500 Service Manual

OTHER FUNCTIONS screen

Item
Saves users files on, loads users files from the storage area of the camera (EEPROM), and initializes
the storage area.
●----: Off (no operation)
●LOAD: Loads the settings in a user file previously stored on the storage area.
USER FILE ●SAVE: Saves the user file updated settings on the storage area.
●INITIAL: Returns the user settings in the user file to their factory defaults.
• After a LOAD or INITIAL operation, turn the POWER switch off and then back on again to make the
new settings available.
• An INITIAL operation does not change the setting of the menu option TIME ZONE.
Sets the control method for backup recording using a backup unit connected to the 1394 terminal.
●OFF: The backup unit is not controlled.
●EXT: The backup unit can be controlled by the START/STOP button. The images shot by the camera
recorder are recorded by the backup unit. Note that the camera recorder does not record them.
1394CONTROL
●BOTH: The images shot by the camera recorder are recorded by both the camera recorder and
●CHAIN: When the camera recorder's media approaches its end during shooting, the backup unit in
Sets how the START/STOP button works for the backup unit.
●REC_P: This switches between recording and pause.
1394CMD SEL
●STOP: This switches between recording and stop.
If the backup unit does not have a rec pause function, select STOP.
Selects the terminal for data transfer. (You cannot select USB and 1394 at the same time.)
●USB DEVICE: Mode for sending files using the USB connector.
●1394 DEVICE: Mode for sending files using the 1394 connector.
PC MODE
●1394 HOST: Mode for copying files from the P2 card onto an external hard disk drive using the 1394
Enables or disables the access LED. The L-SIDE is the left side as seen from the lens (the P2 card slot
side).
●OFF L-SIDE: OFF R-SIDE: OFF
ACCESS LED
●SLOT SIDE L-SIDE: ON R-SIDE: OFF
●LCD SIDE L-SIDE: OFF R-SIDE: ON
●BOTH L-SIDE: ON R-SIDE: OFF
Turns the alarm function on and off.
ALARM
●ON, OFF
Sets the SAVE lamp operation.
●SAVE: Lights when the SAVE/STBY switch is set to SAVE. Off during recording.
SAVE LED
●P2CARD: Blinks when a warning message appears to indicate that there is little space left on a P2
CLOCK SET Sets the camera-recorder's calendar.
Adds to or deducts from GMT the time value of –12:00 to +13:00 in 30-minute steps. (As an exception,
TIME ZONE you can set +12:45.) (Page XX)
●+9:00
Sets the Menu language.
●ENGLISH
LANGUAGE
●JAPANESE
●CHINESE
Determines which signal to lock on to.
GL SELECT
●SDI, COMPOSITE, COMPONENT
Determines whether to perform a 90H shift (ON) or not (OFF).
GL PHASE
●ON, OFF
Adjusts the phase.
H PHASE
●–511 ~ 0 ~ +511
Switches between NTSC and PAL.
SYSTEM FREQ
●59.94 Hz, 50 Hz
Description of settings (Items in bold are factory settings.)
backup unit.
the recording standby mode automatically starts recording images.
connector.
card.
119
Setup menu list