Factory Initialize - Panasonic AG-HPX500 Service Manual

10. Factory Initialize

Please note that the following data etc. are initialized when the FACTORY initialization is executed.
Value of current operating status of setting menu (included scene file F1 to F6) → factory default
Value of user file in EEPROM → factory default
Value of 1394 CONFIG in option menu → default (0)
Counter display → Time code display
Value of TCG/UBG and COUNTER → 0
GUI (thumbnail) menu →factory default
META data
CAC (chromatic aberration compensation) data
NOTE: The value of the hour meter is not reset.
< Initialize procedure >
1. Confirm that the P2 card does not insert in slot of camera recorder.
2. This camera recorder is set to CAM mode.
3. The following three buttons are pushed at the same time for two seconds or more.
[ THUMBNAIL ] + [ REW ] + [ REC START/STOP ]
REC START/STOP button
4. It is blink displayed as "FACTORY INIT" on the LCD panel.
5. After initialization is completed, it replaces the "FACTORY INIT OK: * " display.
The mark * is indicated as shipment destination information. Please confirm that mark is corresponding to the
destination of the camera recorder.
Ex.) In case of AG-HPX500P, it displayed as "P".
NOTE: The model AG-HPX502EN is displayed as "E".
FACTORY INIT
6. Turn power off the camera recorder.
NOTE: Factory initialize can be executed by PC EVR software. Please refer to item "6-4-8. Factory Initialize"
(page INF-30).
THUMBNAIL button
REW button
FACTORY INIT OK: *
TURN POWER OFF
INF-42