7-2. Write EEPROM data from PC to Camera-Recorder
You can return the Camera-Recorder to the condition before board exchanged by writing EEPROM data to new
board, which has been saved before board exchanged.
7-2-1. Write data of Camera-EEPROM
There are three CAMERA EEPROM IC of this unit for NTSC, PAL and LENS data. Because the EVR software can
be written data at a time only by as many as 1 piece of IC, it is necessary to write three files.
1. This camera recorder is set to CAM mode.
2. Select "CAM(C)" section after start up the PC EVR software, and click "OK" button.
3. Select "Open Image File(O)" in "File(F)" menu, the screen for selecting the file to be written will appear.
4. Click "Open(O)" button in the Open screen and reading starts.
NOTE: It is not necessary to specify address (NTSC, PAL or LENS) on the Device View screen. When reading a
file, an address is automatically specified with the data of a file.
5. Select "EEPROM Write(W)" in "File(F)" menu, following message will appear.
When "Cancel(C)" button is clicked, writing EEPROM data is canceled.
When "OK" button is clicked, the writing starts.
INF-36