3. Adjustment after replacement of major parts
When the following parts are exchanged showing in the table, the adjustment and confirmation are required follow
the items shown by mark "X" in the table.
Please refer to item "11. Operation after major part exchanged" of service information (SECTION 1) about
correspondence method when exchanging major parts.
ADJISTMENT ITEM
D-Terminal Output Level Adj.
Video Terminal Output Level Adj.
Int. Frequency Adj.
Blemish Compensation. Adj.
SUB Level Adj.
White Shading Adj. (1)
Standard Sensitivity Adj.
White Balance Adj.
White Shading Adj. (2)
ND FILTER Compensation
X: Adjustment / Confirmation Required
3-1. Adjustment when CAMERA board is exchanged (When no back up
EEPROM data)
Please adjust it according to the content of item 2-3, 2-4, and 2-5.
3-2. Adjustment CAMERA board is exchanged (When back up EEPROM data)
1. Start up the Camera Adjustment software by double-clicking "Camera Adjustment Software.exe". The
Camera Adjustment screen is displayed.
2. The "Execute" button is clicked on the Camera Adjustment screen. Video/Frequency Adj. screen is
displayed.
3. Please adjust the following adjustments according to the content of item "2-3.Adjustment by screen Video /
Frequency Adj. screen".
● D-Terminal Output Level Adjustment
● Video Terminal Output Level Adjustment
● Int. Frequency Adjustment
4. Next please execute "Blemish Compensation Adjustment". Clicking "Blemish Comp. Adj." button, the
Blemish Compensation Adjustment is executed automatically.
Click this button
*CAMERA Board
When
When no
back up
back up
EEPROM
EEPROM
data
data
X
X
X
X
X
X
X
X
X
X
X
X
X
X
ELE-13
PART NAME
Head Optical Ass'y
Camera
CCD FLEX
Ass'y*
SENSOR1
Board
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Front Panel Ass'y
POS
FRONT
SW
BUTTON
Board
Board
The completion massage
is displayed after
adjustment is finished.
REC
Board