Table of Contents
Advertisement
Viewfinder (continued)
Adjusting the screen display
1
Set the POWER/MODE switch to ON.
(Page E-24 of Vol. 1)
2
Press the MENU button.
• For details on menu operation, refer to "Basic
operations of setup menus" (Page E-27 of Vol.
1).
• You can also use the corresponding buttons
on the remote control. For details, see
"Description of parts" (Remote control).
(Page E-18 of Vol. 1)
3
Viewfinder adjustments
Select CHANGE under EVF SETTING on the
setting menu DISPLAY SETUP screen.
LCD monitor adjustments
Set CHANGE under LCD SETTING on the
setting menu DISPLAY SETUP screen.
• When adjusting the viewfinder
EVF PEAK LEVEL
EVF PEAK FREQ
EVF SETTING
EVF B. LIGHT
EVF COLOR
EVF MODE
ZEBRA1 DETECT
ZEBRA2 DETECT
PUSH MENU TO RETURN
4
Push the Operation lever in the or
direction to select the item.
• When adjusting the viewfinder
EVF BRIGHTNESS
[ –] –––––––– + – – – –– – – – [+ ]
EVF CONTRAST
[ –] –––––––– + – – – –– – – – [+ ]
PUSH MENU TO RETURN
5
Push the Operation lever in the or
direction to make adjustment.
• When adjusting the viewfinder
EVF BRIGHTNESS
[ –] –––––––– + – – – –– – – – [+ ]
EVF CONTRAST
[ –] –––––––– + – – – –– – – – [+ ]
PUSH MENU TO RETURN
6
Press MENU three times to exit the menus.
8
DISPLAY SETUP
0
LOW
>>>
NORMAL
ON
AUTO
100%
85%
EVF SETTING
EVF SETTING
• You can return the settings for EVF SETTING
and LCD SETTING to the factory settings by
selecting the item and pressing COUNTER
RESET (if it is possible to change the item at
that time).
• The viewfinder display can be in color or black
and white. (See the setup menus, DISPLAY
SETUP screen, EVF COLOR.) The resolution
is the same for both of them.
Changing backlight brightness
The brightness of the LCD monitor backlight can
be adjusted between five different settings.
1
Select LCD BACKLIGHT from the setup
menu DISPLAY SETUP screen.
2
Select and set a value in the range of +1 to
–3.
The greater the value the brighter the screen.
• This setting will remain saved even if the
camera-recorder's power is switched off.
• You can cycle through LCD BACKLIGHT
values and switch backlight brightness by
pressing a USER button to which "LCD B.L"
has been assigned.
"Using the USER buttons" (Page 39)
Advertisement
Table of Contents
